Outdoor rooms only work when glazing, falls to grade, and services are resolved on the same drawing pass as the kitchen—not as a landscaping addendum. The list below is the sequence BOREC HOMES uses on Sydney sites before joinery shop drawings freeze.
- Views without overheating: Size and shade northern and western glass against eave projection and screen schedules; document external obstructions so certifiers see the model matches the elevation.
- Flush thresholds: Set finished floor levels against paving early so sliding stacks clear tracks, weepholes align to drainage, and door hardware does not foul screens.
- Outdoor kitchens: Group gas, water, and power on one wall with removable access panels; keep bench depths consistent with indoor modules so appliances are not one-off sizes.
- Planting inside: Specify planters with trays and overflows tied to the wet-area floor waste strategy—avoid ad-hoc pots sitting on waterproofing membranes.
- Alfresco dining: Provide two circuits for lighting (task and low glare) and a ceiling cavity for heaters so posts are not added later in the paving field.
- Water features: Pump and filtration loads go on labelled circuits in the switchboard schedule; bund walls and suction points are drawn on the hydraulic sheet, not only on landscape PDFs.
- Landscape interface: Retaining, drainage, and boundary clearances are dimensioned against the built slab—not “approximate at completion.”
If your brief includes pools, deep soil zones, or BAL ratings, those metrics ride in the same issue set as the architecture. For a review of your survey against a preferred plan typology, contact BOREC HOMES with DA conditions attached.